MetalworkingFun Forum › Machining › Metrology v
Got a surface plate

Thread Modes
Got a surface plate
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 2 users Like PixMan's post:
EdK (04-11-2015), stevec (04-12-2015)
#15
04-11-2015, 08:20 PM
(04-11-2015, 03:32 AM)Hopefuldave Wrote: If nobody wants it for their lab, an optical table at work might be up for grabs - but at 9' x 4'6" and about half a ton I can't see a way to get it home :'(

Sounds about right for making one of the smoothest, straightest billiards table EVER.
Reply
Thanks given by:


Messages In This Thread
Got a surface plate - by JScott - 04-10-2015, 10:25 AM
RE: Got a surface plate - by Roadracer_Al - 04-10-2015, 11:05 AM
RE: Got a surface plate - by JScott - 04-10-2015, 11:27 AM
RE: Got a surface plate - by Highpower - 04-10-2015, 02:53 PM
RE: Got a surface plate - by JScott - 04-10-2015, 03:43 PM
RE: Got a surface plate - by PixMan - 04-10-2015, 01:53 PM
RE: Got a surface plate - by DaveH - 04-10-2015, 02:56 PM
RE: Got a surface plate - by Highpower - 04-10-2015, 03:14 PM
RE: Got a surface plate - by Roadracer_Al - 04-10-2015, 07:13 PM
RE: Got a surface plate - by Vinny - 04-10-2015, 07:36 PM
RE: Got a surface plate - by Mayhem - 04-11-2015, 02:03 AM
RE: Got a surface plate - by Hopefuldave - 04-11-2015, 03:32 AM
RE: Got a surface plate - by Highpower - 04-11-2015, 11:16 AM
RE: Got a surface plate - by PixMan - 04-11-2015, 08:20 PM
RE: Got a surface plate - by dallen - 04-11-2015, 07:40 AM



Users browsing this thread: 2 Guest(s)