05-20-2012, 06:39 AM
Wong,
No definitely not for the scrap bin.
It is looking good, you have nearly done the difficult bit and if your 3 jaw chuck does the same rocking may be like Rob has said there is a slight "bur" on the spindle flange.
Just check the spindle flange, carefully, very carefully "wipe" it with some very fine emery paper, especially any edges. Also check for "burs" around the holes.
Follow Rob's suggestions as well and it is going to come out perfect
DaveH
No definitely not for the scrap bin.
It is looking good, you have nearly done the difficult bit and if your 3 jaw chuck does the same rocking may be like Rob has said there is a slight "bur" on the spindle flange.
Just check the spindle flange, carefully, very carefully "wipe" it with some very fine emery paper, especially any edges. Also check for "burs" around the holes.
Follow Rob's suggestions as well and it is going to come out perfect
DaveH