05-19-2012, 11:45 PM
I was rather curious to find out if the recess fits the bore on the spindle flange. Went back to the shop and take everything off and fit the work.
It seems to fit nicely...
![[Image: 6f8194ae.jpg]](http://i1207.photobucket.com/albums/bb469/wongstersproduction/ER32%20Collet%20Chuck/6f8194ae.jpg)
Look ma, no hands!
![[Image: 8a85fb33.jpg]](http://i1207.photobucket.com/albums/bb469/wongstersproduction/ER32%20Collet%20Chuck/8a85fb33.jpg)
Pushing the flange of the chuck to be against the flange with one hand, I started rocking the piece. I can feel slight movement and some knocking sound at certain point... boy am I disappointed...
I put on the 3 jaw chuck (without the bolts) and did the same. The slight movements and a little knocking sound is also there.
Do I declare my work so far resident of the scrap bin? Any remedy?
Regards,
Wong
It seems to fit nicely...
Look ma, no hands!
Pushing the flange of the chuck to be against the flange with one hand, I started rocking the piece. I can feel slight movement and some knocking sound at certain point... boy am I disappointed...
I put on the 3 jaw chuck (without the bolts) and did the same. The slight movements and a little knocking sound is also there.
Do I declare my work so far resident of the scrap bin? Any remedy?
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.