04-02-2015, 08:39 AM
(This post was last modified: 04-02-2015, 08:41 AM by Bill Gruby.)
Good Morning everyone. I have a meeting at the Nursing Home to discuss the move of my wife. She will be there for a short time before coming home. The main this is that she is strong enough to leave the Hospital. All is well here.
OK, last night I had a thought. The table is to plain. So, I think I will "Engine Turn" the entire top. Yes, it's a massive undertaking, but doable. This is what it will look like, no abrasives were used, only lite oil and a 1 inch birch dowel. It's been a long time since I last did this, so it will take a little practice. You only get one shot at it, mistakes are forever.
The plan is to use the pattern in the second picture, the small piece. The "Swirl" is pronounced at the center as it should be.
"Billy G"
OK, last night I had a thought. The table is to plain. So, I think I will "Engine Turn" the entire top. Yes, it's a massive undertaking, but doable. This is what it will look like, no abrasives were used, only lite oil and a 1 inch birch dowel. It's been a long time since I last did this, so it will take a little practice. You only get one shot at it, mistakes are forever.
The plan is to use the pattern in the second picture, the small piece. The "Swirl" is pronounced at the center as it should be.
"Billy G"