MetalworkingFun Forum › Machining › Projects v
Tailstock Tap Guide

Thread Modes
Tailstock Tap Guide
Micktoon Offline
Junior
****
Posts: 638
Threads: 43
Joined: Sep 2012
Location: England
#2
04-01-2015, 04:57 AM
Hi aRM, that looks as good as anything I have seen , very nice job. How big is it ? Its hard to tell from the photos but you have mentioned the one you can buy are too small.

 Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
Tailstock Tap Guide - by aRM - 04-01-2015, 12:18 AM
RE: TAILSTOCK TAP GUIDE - by Micktoon - 04-01-2015, 04:57 AM
RE: TAILSTOCK TAP GUIDE - by aRM - 04-01-2015, 01:12 PM
RE: TAILSTOCK TAP GUIDE - by gman6011 - 04-01-2015, 06:23 AM
RE: TAILSTOCK TAP GUIDE - by RobWilson - 04-01-2015, 07:08 AM
RE: TAILSTOCK TAP GUIDE - by aRM - 04-01-2015, 01:17 PM
RE: TAILSTOCK TAP GUIDE - by DaveH - 04-01-2015, 08:05 AM
RE: TAILSTOCK TAP GUIDE - by EdK - 04-01-2015, 08:13 AM
RE: TAILSTOCK TAP GUIDE - by Mayhem - 04-01-2015, 08:32 AM
RE: TAILSTOCK TAP GUIDE - by EdK - 04-01-2015, 09:08 AM
RE: TAILSTOCK TAP GUIDE - by aRM - 04-01-2015, 01:36 PM
RE: TAILSTOCK TAP GUIDE - by Mayhem - 04-01-2015, 09:52 AM
RE: TAILSTOCK TAP GUIDE - by EdK - 04-01-2015, 10:04 AM
RE: TAILSTOCK TAP GUIDE - by f350ca - 04-01-2015, 01:14 PM
RE: TAILSTOCK TAP GUIDE - by Mayhem - 04-01-2015, 10:13 AM
RE: TAILSTOCK TAP GUIDE - by Highpower - 04-01-2015, 04:01 PM
RE: TAILSTOCK TAP GUIDE - by stevec - 04-01-2015, 04:08 PM
RE: TAILSTOCK TAP GUIDE - by EdK - 04-01-2015, 04:27 PM
RE: TAILSTOCK TAP GUIDE - by stevec - 04-01-2015, 04:32 PM
RE: TAILSTOCK TAP GUIDE - by Vinny - 04-01-2015, 04:52 PM
RE: Tailstock Tap Guide - by EdK - 04-01-2015, 05:04 PM
RE: Tailstock Tap Guide - by Micktoon - 04-01-2015, 05:09 PM
RE: Tailstock Tap Guide - by aRM - 04-01-2015, 10:19 PM



Users browsing this thread: 2 Guest(s)