03-28-2015, 09:06 AM
I'm trying to follow along with the development of the code. Can either Ed or Arvid post the entire code you're using at this point?
As the weather is cool again this week end, I'm going to reorganize my desk and get back into playing with this project.
And to make sure I'm on the same page, you are using the cheap HF Calipers, right?
Chuck
As the weather is cool again this week end, I'm going to reorganize my desk and get back into playing with this project.
And to make sure I'm on the same page, you are using the cheap HF Calipers, right?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.