ER32 Collet Chuck for Proxxon PD 400
#63
Hi Rob,

Slow would be the word but I'm not complaining. Rotfl

Actually had some opportunities during weekdays but was feeling lazy after long day at work. I'll be on compliance leave for 2 weeks soon. Will want to shop for a mill.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 04-15-2012, 06:35 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 04-16-2012, 09:29 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 04-16-2012, 10:13 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 04-16-2012, 11:11 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 04-16-2012, 12:36 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-01-2012, 09:06 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-01-2012, 11:23 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-01-2012, 12:22 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-07-2012, 06:20 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 05-19-2012, 04:23 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by Wongster - 05-19-2012, 05:27 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 05-20-2012, 04:37 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 05-20-2012, 01:07 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-20-2012, 01:23 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 05-20-2012, 01:40 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 05-20-2012, 03:25 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 05-31-2012, 04:26 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by RobWilson - 06-01-2012, 02:40 AM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 06-20-2012, 08:06 PM
RE: ER32 Collet Chuck for Proxxon PD 400 - by EdK - 06-25-2012, 03:14 PM



Users browsing this thread: 4 Guest(s)