|
Hinges
|
|
03-25-2015, 08:43 PM
(03-25-2015, 06:43 PM)TomG Wrote: .....or if you already have the ball bearings, maybe you could drill some smaller holes to locate them and weld them in place from the back side. Good idea. Just be sure that when you install the bearings, to put the bottom of the ball toward the smaller hole before welding them so they are standing right side up.
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Hinges - by PixMan - 03-23-2015, 06:55 PM
RE: Hinges - by f350ca - 03-23-2015, 07:41 PM
RE: Hinges - by PixMan - 03-23-2015, 08:41 PM
RE: Hinges - by Vinny - 03-24-2015, 10:07 AM
RE: Hinges - by TomG - 03-24-2015, 05:05 PM
RE: Hinges - by Vinny - 03-24-2015, 10:14 PM
RE: Hinges - by PixMan - 03-24-2015, 10:48 PM
RE: Hinges - by Brian - 03-25-2015, 01:55 AM
RE: Hinges - by Vinny - 03-25-2015, 07:49 AM
RE: Hinges - by Micktoon - 03-25-2015, 08:23 AM
RE: Hinges - by dallen - 03-25-2015, 08:35 AM
RE: Hinges - by Vinny - 03-25-2015, 04:45 PM
RE: Hinges - by dallen - 03-25-2015, 04:57 PM
RE: Hinges - by Vinny - 03-25-2015, 05:25 PM
RE: Hinges - by dallen - 03-25-2015, 06:25 PM
RE: Hinges - by TomG - 03-25-2015, 06:43 PM
RE: Hinges - by Highpower - 03-25-2015, 08:43 PM
RE: Hinges - by Vinny - 03-26-2015, 04:53 PM
|
