|
Hinges
|
03-25-2015, 01:55 AM
I think If I had to make that part and originality was not required. Steel angle would be my choice of material , the dimples put in with the end of a drill. and for the mating part simply drill and tap then screw in dome headed screws with Loctite. after painting no one will know .
But I always am simple minded. Brian. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Hinges - by PixMan - 03-23-2015, 06:55 PM
RE: Hinges - by f350ca - 03-23-2015, 07:41 PM
RE: Hinges - by PixMan - 03-23-2015, 08:41 PM
RE: Hinges - by Vinny - 03-24-2015, 10:07 AM
RE: Hinges - by TomG - 03-24-2015, 05:05 PM
RE: Hinges - by Vinny - 03-24-2015, 10:14 PM
RE: Hinges - by PixMan - 03-24-2015, 10:48 PM
RE: Hinges - by Brian - 03-25-2015, 01:55 AM
RE: Hinges - by Vinny - 03-25-2015, 07:49 AM
RE: Hinges - by Micktoon - 03-25-2015, 08:23 AM
RE: Hinges - by dallen - 03-25-2015, 08:35 AM
RE: Hinges - by Vinny - 03-25-2015, 04:45 PM
RE: Hinges - by dallen - 03-25-2015, 04:57 PM
RE: Hinges - by Vinny - 03-25-2015, 05:25 PM
RE: Hinges - by dallen - 03-25-2015, 06:25 PM
RE: Hinges - by TomG - 03-25-2015, 06:43 PM
RE: Hinges - by Highpower - 03-25-2015, 08:43 PM
RE: Hinges - by Vinny - 03-26-2015, 04:53 PM
|
