MetalworkingFun Forum › Machining › Projects v
Hinges

Thread Modes
Hinges
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#6
03-24-2015, 05:05 PM
Are you sure the originals use loose balls? All of the hinges like that I've seen use a male/female stamped disc, clamped together with a threaded shaft and knob. I would suspect that the missing halves have raised dimples to mate with the parts you have, not loose balls.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Hinges - by Vinny - 03-23-2015, 05:49 PM
RE: Hinges - by PixMan - 03-23-2015, 06:55 PM
RE: Hinges - by f350ca - 03-23-2015, 07:41 PM
RE: Hinges - by PixMan - 03-23-2015, 08:41 PM
RE: Hinges - by Vinny - 03-24-2015, 10:07 AM
RE: Hinges - by TomG - 03-24-2015, 05:05 PM
RE: Hinges - by Vinny - 03-24-2015, 10:14 PM
RE: Hinges - by PixMan - 03-24-2015, 10:48 PM
RE: Hinges - by Brian - 03-25-2015, 01:55 AM
RE: Hinges - by Vinny - 03-25-2015, 07:49 AM
RE: Hinges - by Micktoon - 03-25-2015, 08:23 AM
RE: Hinges - by dallen - 03-25-2015, 08:35 AM
RE: Hinges - by Vinny - 03-25-2015, 04:45 PM
RE: Hinges - by dallen - 03-25-2015, 04:57 PM
RE: Hinges - by Vinny - 03-25-2015, 05:25 PM
RE: Hinges - by dallen - 03-25-2015, 06:25 PM
RE: Hinges - by TomG - 03-25-2015, 06:43 PM
RE: Hinges - by Highpower - 03-25-2015, 08:43 PM
RE: Hinges - by Vinny - 03-26-2015, 04:53 PM



Users browsing this thread: 3 Guest(s)