03-22-2015, 04:24 AM
I just found a three phase 1HP motor with a 7:1 reduction on it. I'm thinking of converting a wood cutting bandsaw that I have.
The fan cover is off, as I had to mark one of the blades to figure out the ratio. The will result in about 195 rpm, so I'll have to look at the pulley size on the bandsaw and work out what SFM I will end up with.
The fan cover is off, as I had to mark one of the blades to figure out the ratio. The will result in about 195 rpm, so I'll have to look at the pulley size on the bandsaw and work out what SFM I will end up with.
Hunting American dentists since 2015.