I have an RPC that runs my 5hp Logan lathe and my Harig 6X12 surface grinder (not at the same time). Purchased the box from Phase Craft on EBay and a used 10hp Lincoln motor from a local motor repair shop. Quite happy with the set-up. I could put a 5hp 3 phase on the planner, but given the weight of the table I'm not sure it have enough power.
Phase Craft also sells a 7.5 to 10 hp static phase converter for $99.99. Will need to call him for advice.
Just looked on EBay for VFDs. Need to do some more research, but will probably go that direction.
The ways have some surface rust, but no pitting. I should be able to clean them with penetrating oil and some elbow grease.
I should spray them down with some LPS #3 for now so they do not get worse before I start the refurb.
Phase Craft also sells a 7.5 to 10 hp static phase converter for $99.99. Will need to call him for advice.
Just looked on EBay for VFDs. Need to do some more research, but will probably go that direction.
The ways have some surface rust, but no pitting. I should be able to clean them with penetrating oil and some elbow grease.
I should spray them down with some LPS #3 for now so they do not get worse before I start the refurb.