03-19-2015, 06:34 PM
Might be a reason to buy a spot welder for the stainless.
Then when it will only do up to 1/8", you could say, you need to rivet it in thicker stock for safety reasons, so send for some stainless rod.
When that causes you to hit your thumb (just use some purple and black magic marker) tell her a TIG rig is too expensive, mybe you should just give up........unless?
Then when it will only do up to 1/8", you could say, you need to rivet it in thicker stock for safety reasons, so send for some stainless rod.
When that causes you to hit your thumb (just use some purple and black magic marker) tell her a TIG rig is too expensive, mybe you should just give up........unless?