05-18-2012, 05:40 PM
not that quality lathe that you made me dig out of a barn 
That bit bar was the best part
I will lend you my camera ,,,,,,,, see if it works for you
Rob
|
Mill Vice Stop
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill Vice Stop - by doubleboost - 05-16-2012, 05:32 PM
RE: Mill Vice Stop - by stevec - 05-16-2012, 05:40 PM
RE: Mill Vice Stop - by doubleboost - 05-16-2012, 05:50 PM
RE: Mill Vice Stop - by DaveH - 05-16-2012, 05:51 PM
RE: Mill Vice Stop - by doubleboost - 05-16-2012, 05:53 PM
RE: Mill Vice Stop - by ETC57 - 05-16-2012, 08:55 PM
RE: Mill Vice Stop - by krv3000 - 05-17-2012, 04:36 AM
RE: Mill Vice Stop - by doubleboost - 05-18-2012, 04:32 PM
RE: Mill Vice Stop - by EdK - 05-18-2012, 05:03 PM
RE: Mill Vice Stop - by RobWilson - 05-18-2012, 05:10 PM
RE: Mill Vice Stop - by EdK - 05-18-2012, 05:15 PM
RE: Mill Vice Stop - by doubleboost - 05-18-2012, 05:25 PM
RE: Mill Vice Stop - by RobWilson - 05-18-2012, 05:40 PM
RE: Mill Vice Stop - by stevec - 05-18-2012, 07:58 PM
RE: Mill Vice Stop - by doubleboost - 05-19-2012, 04:30 AM
RE: Mill Vice Stop - by doubleboost - 05-19-2012, 03:40 PM
RE: Mill Vice Stop - by DaveH - 05-19-2012, 03:56 PM
RE: Mill Vice Stop - by EdK - 05-19-2012, 04:30 PM
RE: Mill Vice Stop - by RobWilson - 05-19-2012, 04:42 PM
RE: Mill Vice Stop - by doubleboost - 05-19-2012, 04:56 PM
RE: Mill Vice Stop - by Wongster - 05-19-2012, 06:58 PM
|
Users browsing this thread: 2 Guest(s)