Surface grinder books ?
#6
Something that causes grief is the magnetic chuck holding thin parts. The chuck will pull your part flat down, but it springs back into a curve when released. Is that what you mean by "straight"? Try using paper shims.

Single phase conversion here too. Works fine. Smile
Reply
Thanks given by:


Messages In This Thread
Surface grinder books ? - by 12345678910 - 03-16-2015, 05:36 PM
RE: Surface grinder books ? - by EdK - 03-16-2015, 05:38 PM
RE: Surface grinder books ? - by arvidj - 03-16-2015, 07:22 PM
RE: Surface grinder books ? - by f350ca - 03-16-2015, 07:31 PM
RE: Surface grinder books ? - by Dr Stan - 03-16-2015, 10:31 PM
RE: Surface grinder books ? - by Sunset Machine - 03-17-2015, 07:39 AM
RE: Surface grinder books ? - by Dr Stan - 03-17-2015, 02:16 PM
RE: Surface grinder books ? - by tekfab - 03-17-2015, 10:38 AM



Users browsing this thread: 1 Guest(s)