Checking My Nuts

[EdK]

(03-16-2015, 11:41 AM)EdK Wrote:

(03-16-2015, 09:25 AM)f350ca Wrote: Your threading tool shouldn't grab, it has no rake, but as Ken warned watch when you drill out the hole, Tom had a good tip on removing the edge on your drill bit.
Also interested in your bronze source, I need some 1 3/4 od x 1 1/2 id bushings, they want $20 each for them.

I may have a piece of cored bronze at home in that size that I could send you. I'll check when I get home from work.

Ed

Greg,

I have what I believe to be sintered bronze 15/16" ID x 2 1/16" OD x 6 3/4" L. At first I thought it was brass but then I put it next to a brass rod and my just arrived 660 bronze and it's definitely not brass. Let me know if this would work for you.

Ed