05-18-2012, 04:15 PM
Ron,
that lubricator/regulator will have an inlet with NPT on the far side of it as you have the picture. Probably 1/4 NPT, but need to check it.
Have fun with the lift. I think others have reminded you to keep the load low, and that's good advice. A safety strap back to the mast is a good idea as well. I have moved many a bp type mill with a couple of 2 x 4 on top of the forks, lifting under the dovetails on the turret. You probably can't go through a garage door, but it makes setting it on a pallet jack or rollers easy.
that lubricator/regulator will have an inlet with NPT on the far side of it as you have the picture. Probably 1/4 NPT, but need to check it.
Have fun with the lift. I think others have reminded you to keep the load low, and that's good advice. A safety strap back to the mast is a good idea as well. I have moved many a bp type mill with a couple of 2 x 4 on top of the forks, lifting under the dovetails on the turret. You probably can't go through a garage door, but it makes setting it on a pallet jack or rollers easy.