03-14-2015, 10:48 PM
Ed,
I ran the TTGen software and got that a 1"-10ACME is a 1.919º helix angle, so you'd be able to use one of the internal threading bars they and Carmex offer, as long as it has interchangeable anvils and you substitute the standard YI-2 for a YI-3. I have one of those, I just have to run over to the shop tomorrow to see if I have the 3/4" bar with the anvils.
I can't remember every tool I've stocked, and the tooling database that I know will be mentioned now is on my home PC that's 7.5 miles from my shop so I have to depend upon a fading memory for these things for now.
You would have to get the insert, about $17.76 for one from KBC Tool.
I ran the TTGen software and got that a 1"-10ACME is a 1.919º helix angle, so you'd be able to use one of the internal threading bars they and Carmex offer, as long as it has interchangeable anvils and you substitute the standard YI-2 for a YI-3. I have one of those, I just have to run over to the shop tomorrow to see if I have the 3/4" bar with the anvils.
I can't remember every tool I've stocked, and the tooling database that I know will be mentioned now is on my home PC that's 7.5 miles from my shop so I have to depend upon a fading memory for these things for now.
You would have to get the insert, about $17.76 for one from KBC Tool.