03-14-2015, 06:02 PM
(03-14-2015, 05:44 PM)Mayhem Wrote:(03-14-2015, 01:34 PM)PixMan Wrote: ...Oh well, ready for the next one!
I'm hoping it won't come to that. However, I'm sure you will find something to use it on.
And the "something else to use it on" is just what I had in mind when I clicked on the "Make An Offer" option.
I couldn't actually use it on making another bronze nut for you because it can only cut right hand threads. If it were a larger one with an interchangeable anvil under the insert, I could swap out the anvil to a negative rake on and do LH threads, but it wouldn't be small enough to get into the 1.05" bore.
The most likely situation would be right hand threads of 7, 6, or 5 TPI where I may not have the power to use a tap. I do have up to 1-1/4-7 taps, but it would be easier to thread on the lathe.