Log Splitter

[f350ca]

(03-13-2015, 02:18 PM)DaveH Wrote: Thanks Greg,
So after I finish at 2,  I start to weld from 5 to 3 remembering to clean up the tack at 3 ......... is this correct.
 
DaveH

2 is in the middle of a side, i'd try to do the sides in continuous passes. If you need to stop to change rods, scratch you're ear whatever, clean up the end of the weld with a thin disk to be sure there's no slag to leave a pin hole.
Or 3 to 5, just going around the cap, once its tacked it should stay flat.