03-12-2015, 01:03 PM
On the crank (sheet 8) there is a .5" diameter pin. If this pin is positioned to give a 2" vertical stroke, then the distance from the outside of the pin to the center of the crank is 1.25". The out side of the pin will 'scribe' a 2.5" diameter circle.
The yoke (sheet 9) shows an area "Mill out this area" 2.125" x .5" the length needs to be increased to at least 2.5" to accommodate when the pin is at 3'o clock and 9'o clock.
DaveH
The yoke (sheet 9) shows an area "Mill out this area" 2.125" x .5" the length needs to be increased to at least 2.5" to accommodate when the pin is at 3'o clock and 9'o clock.
DaveH