03-09-2015, 07:13 PM
I missed a few posts, as I took advantage of the warmer weather and worked in the shop a while today.
Going back to post 21, Ed I copied your code and it worked after I changed the data and clock pins to match my hookup. That is I get an output of numbers on the serial monitor, but I don't know what I'm seeing. The caliper currently reads -2.57mm. Attachment is a screen capture of the serial monitor. I unplugged the Arduino to make the screen capture. I think the output s just a count of milliseconds, right?
Chuck
Going back to post 21, Ed I copied your code and it worked after I changed the data and clock pins to match my hookup. That is I get an output of numbers on the serial monitor, but I don't know what I'm seeing. The caliper currently reads -2.57mm. Attachment is a screen capture of the serial monitor. I unplugged the Arduino to make the screen capture. I think the output s just a count of milliseconds, right?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.