Billy G's Die Filer

[EdK]

(03-09-2015, 02:57 PM)RobWilson. Wrote: Hi Ed , canny drawings ,nice going .

There is a measurement on the side plate of 14.625 the hight to the bottom of the chamfer , its not needed , what is is the measurement of  3.25 , the width of the plate .

Just think when someone starts a part the first thing is what materials and what size ,  size of material required to make the part from . LxWxT

Post not meant as criticism .

Rob (interested party)

Hi Rob,

No worries, I'm glad someone is checking them over. I encourage opinions of the drawings.

Yup, I knew that 14.625 dimension didn't need to be there but I put it on anyway. I've removed it. Good catch on the width of the side. You guess right, it's 3.25.

I didn't list the material on most of the drawings because I think the majority of the parts could be made from either steel or aluminum, with some exceptions.

Updated drawings attached. Keep the critiques coming.  

Ed


  Die Filer 03.pdf (Size: 237.72 KB / Downloads: 16)