03-08-2015, 10:32 PM
Hey now, I did NOT try to get you to buy a Triumph! I tried to get you to simply take a ride on one, and still would today.
THEN you would rush out and buy one.
Scared, aren't you?
That V555 cutter is exactly what I mean about low force cutter geometry. It's got both axial shear angle and radial rake. And it's very similar in performance to my F4080's, except that it gets better finishes at a given feed rate than mine, but I got eight corners per insert. And PLENTY of 'em!
THEN you would rush out and buy one.
Scared, aren't you?
That V555 cutter is exactly what I mean about low force cutter geometry. It's got both axial shear angle and radial rake. And it's very similar in performance to my F4080's, except that it gets better finishes at a given feed rate than mine, but I got eight corners per insert. And PLENTY of 'em!