Lathe table

Thread Modes

Lathe table

PixMan Offline

Resident Pariah

Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA

The following 1 user Likes PixMan's post:
confederatemule (03-08-2015)

#11

03-08-2015, 02:30 PM

Now that I think about it, I can't tell it those cabinets are wood or metal! To put the next together you should trim the tops off on the mating sides so they can mate up tight, fasten them together and either skim the tops off or shim to match the heights.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Lathe table - by confederatemule - 03-04-2015, 06:08 PM

RE: Lathe table - by Vinny - 03-04-2015, 06:13 PM

RE: Lathe table - by EdK - 03-04-2015, 06:23 PM

RE: Lathe table - by confederatemule - 03-04-2015, 06:33 PM

RE: Lathe table - by fix - 03-05-2015, 05:42 AM

RE: Lathe table - by fix - 03-05-2015, 05:46 AM

RE: Lathe table - by confederatemule - 03-05-2015, 09:25 PM

RE: Lathe table - by dallen - 03-06-2015, 09:01 AM

RE: Lathe table - by PixMan - 03-05-2015, 11:53 PM