03-08-2015, 08:58 AM
Billy,
The 3" diameter dimension on the table I assume is a counter-bore for an insert, correct? I've made it .125" deep but can always change it easy enough.
On the yoke guide print there's a 2.000" dimension at the bottom of the part but no notes as to what it's dimensioning. I assume it's probably for a couple of tapped holes.
On the spindle housing print you have the total width of the part as 2.875" but when you add up the dimensions it adds up to 3.00".
Ed
The 3" diameter dimension on the table I assume is a counter-bore for an insert, correct? I've made it .125" deep but can always change it easy enough.
On the yoke guide print there's a 2.000" dimension at the bottom of the part but no notes as to what it's dimensioning. I assume it's probably for a couple of tapped holes.
On the spindle housing print you have the total width of the part as 2.875" but when you add up the dimensions it adds up to 3.00".
Ed