03-08-2015, 07:40 AM
I'm using a HF cheap scale and an Arduino Uno. I am trying to get a display on the Serial Monitor of the Arduino IDE.
I am using the hookup and schematic from here:
http://www.instructables.com/id/Reading-...duino-USB/
The sketch displays only one 0, but the caliper is powered and working using the led and resistor circuit shown there. I think the code listed there is for a different protocol.
I am not, nor do I pretend to be, a programmer and I did not stay at a Holiday Inn last night...
Chuck
I am using the hookup and schematic from here:
http://www.instructables.com/id/Reading-...duino-USB/
The sketch displays only one 0, but the caliper is powered and working using the led and resistor circuit shown there. I think the code listed there is for a different protocol.
I am not, nor do I pretend to be, a programmer and I did not stay at a Holiday Inn last night...
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.