Billy G's Die Filer

[RobWilson]

Hi Lads

I am confused (easy done ) this first drawing (post #42) shows what I believe to be the pivot point (large hole ) concentric with the to radial slots .

Then redrawn in post #48 were the two radial slots dont look to be concentric with what I believe to be the pivot point (large hole), amusing that the two radial slots are there so that the table can be locked at different angles .

Is the larger hole a pivot point ?

Are the two radial slots for angle adjustment ?

If above both yes then assembly will not pivot , or am I missing something ?


Cheers Rob