03-06-2015, 06:38 PM
OK, so what piece are you referring to when you said "That piece is made from 6.000 diameter 6061, 1 inch thick. Two can be made at the same time. I gave you a cutting guide to show this. The center is bored to 5.000 diameter X .5625 deep, then thye parts are cut."?
Not trying to be difficult but since I've not seen a completed die filer I'm a kind of running blind here. Which is a good thing because I think the drawings will end up being much better because of my ignorance and the need to ask copious amounts of questions.
Ed
Not trying to be difficult but since I've not seen a completed die filer I'm a kind of running blind here. Which is a good thing because I think the drawings will end up being much better because of my ignorance and the need to ask copious amounts of questions.
Ed