MetalworkingFun Forum › Machining › Metrology v
Edge finder

Thread Modes
Edge finder
Tony Wells Offline
Sophmore
***
Posts: 200
Threads: 4
Joined: Feb 2012
Location: Tyler, TX USA
#14
03-02-2015, 12:27 PM
That was my very first edge finder. I either blued the pin, or used a marks-a-lot (pre sharpie days). DP's are usually a couple of tenths under, but they run out a bit, as Tom mentioned, so for most work, it averages out.
Reply
Thanks given by:


Messages In This Thread
Edge finder - by mike-sid - 02-28-2015, 01:29 PM
RE: Edge finder - by f350ca - 02-28-2015, 01:54 PM
RE: Edge finder - by EdK - 02-28-2015, 01:56 PM
RE: Edge finder - by Highpower - 02-28-2015, 02:43 PM
RE: Edge finder - by Vinny - 02-28-2015, 03:11 PM
RE: Edge finder - by TomG - 02-28-2015, 11:01 PM
RE: Edge finder - by mike-sid - 03-01-2015, 06:22 AM
RE: Edge finder - by Highpower - 03-01-2015, 01:10 PM
RE: Edge finder - by Arbalest - 03-01-2015, 01:30 PM
RE: Edge finder - by Highpower - 03-01-2015, 02:02 PM
RE: Edge finder - by mike-sid - 03-01-2015, 02:45 PM
RE: Edge finder - by f350ca - 03-01-2015, 03:19 PM
RE: Edge finder - by TomG - 03-01-2015, 10:49 PM
RE: Edge finder - by Tony Wells - 03-02-2015, 12:27 PM
RE: Edge finder - by Vinny - 03-03-2015, 06:11 PM
RE: Edge finder - by EdK - 03-04-2015, 05:05 PM
RE: Edge finder - by TomG - 03-03-2015, 07:49 PM
RE: Edge finder - by Vinny - 03-04-2015, 05:15 PM
RE: Edge finder - by Tony Wells - 03-05-2015, 01:55 AM
RE: Edge finder - by DaveH - 03-05-2015, 03:27 AM
RE: Edge finder - by TomG - 03-05-2015, 06:54 AM
RE: Edge finder - by EdK - 03-05-2015, 06:55 AM
RE: Edge finder - by PixMan - 03-05-2015, 03:49 PM
RE: Edge finder - by Roadracer_Al - 03-05-2015, 09:02 PM
RE: Edge finder - by Highpower - 03-05-2015, 10:52 PM
RE: Edge finder - by flosi - 04-08-2015, 02:48 PM
RE: Edge finder - by Sunset Machine - 04-09-2015, 07:52 AM
RE: Edge finder - by rleete - 04-09-2015, 04:49 PM
RE: Edge finder - by Highpower - 04-09-2015, 05:15 PM
RE: Edge finder - by flosi - 04-09-2015, 05:14 PM
RE: Edge finder - by TomG - 04-09-2015, 05:38 PM



Users browsing this thread: 1 Guest(s)