316L stainless basics?
#8
Another thing to know about cutting and drilling stainless is this: don't mince about! If you use light feed pressure, it will work harden, then just rub and dull your cutting tools. You want to use a good lube (I have stick wax for the bandsaw, and sulfured cutting oil for milling and lathing ops) and use enough feed to get a substantial chip.
Reply
Thanks given by:


Messages In This Thread
316L stainless basics? - by jawnn - 02-19-2015, 02:39 PM
RE: 316L stainless basics? - by PixMan - 02-19-2015, 10:05 PM
RE: 316L stainless basics? - by stevec - 02-20-2015, 07:28 AM
RE: 316L stainless basics? - by TomG - 02-20-2015, 09:01 AM
RE: 316L stainless basics? - by jawnn - 02-21-2015, 03:41 PM
RE: 316L stainless basics? - by PixMan - 02-21-2015, 03:49 PM
RE: 316L stainless basics? - by f350ca - 02-21-2015, 06:10 PM
RE: 316L stainless basics? - by Roadracer_Al - 02-22-2015, 01:20 PM
RE: 316L stainless basics? - by PixMan - 02-22-2015, 03:55 PM



Users browsing this thread: 6 Guest(s)