any advice for a 3 axis DRO for my mill?

Hello There, Guest! Register

Thread Modes

any advice for a 3 axis DRO for my mill?

mike-sid Offline

Offline

Sophmore

Posts: 137
Threads: 16
Joined: Jan 2015
Location: Oxford, CT

#2

02-22-2015, 10:35 AM

My mill's table is about 6.5"×25"

Reply

« Next Oldest | Next Newest »

Messages In This Thread

any advice for a 3 axis DRO for my mill? - by mike-sid - 02-22-2015, 10:19 AM

RE: any advice for a 3 axis DRO for my mill? - by mike-sid - 02-22-2015, 10:35 AM

RE: any advice for a 3 axis DRO for my mill? - by EdK - 02-22-2015, 11:04 AM

RE: any advice for a 3 axis DRO for my mill? - by mike-sid - 02-22-2015, 03:42 PM

RE: any advice for a 3 axis DRO for my mill? - by EdK - 02-22-2015, 06:01 PM

RE: any advice for a 3 axis DRO for my mill? - by f350ca - 02-22-2015, 06:24 PM

RE: any advice for a 3 axis DRO for my mill? - by EdK - 02-22-2015, 06:51 PM

RE: any advice for a 3 axis DRO for my mill? - by Highpower - 02-22-2015, 11:14 PM

RE: any advice for a 3 axis DRO for my mill? - by mike-sid - 02-22-2015, 07:26 PM

RE: any advice for a 3 axis DRO for my mill? - by Dr Stan - 02-22-2015, 11:19 PM

RE: any advice for a 3 axis DRO for my mill? - by f350ca - 02-22-2015, 11:39 PM

RE: any advice for a 3 axis DRO for my mill? - by Highpower - 02-23-2015, 01:52 AM

RE: any advice for a 3 axis DRO for my mill? - by PixMan - 02-23-2015, 06:53 PM

RE: any advice for a 3 axis DRO for my mill? - by mike-sid - 02-25-2015, 11:00 PM

Users browsing this thread: 2 Guest(s)