316L stainless basics?
#5
I was reading some thing about how it needs to be oxidized, or the first layer stops penetration. and some one once told me that oxidation was needed. ok wont worry about it.

I need to bend the eighth inch bar at 90 degrees but not too sharply. I got quarter inch for the down arms, a bit too heavy. it will be stronger than any other bicycle rack.

And only my self will be able to ride this cycle truck, unless I put a motor on it. Google utilitycyclingtechnology, if you want to see what I am up to.
Reply
Thanks given by:


Messages In This Thread
316L stainless basics? - by jawnn - 02-19-2015, 02:39 PM
RE: 316L stainless basics? - by PixMan - 02-19-2015, 10:05 PM
RE: 316L stainless basics? - by stevec - 02-20-2015, 07:28 AM
RE: 316L stainless basics? - by TomG - 02-20-2015, 09:01 AM
RE: 316L stainless basics? - by jawnn - 02-21-2015, 03:41 PM
RE: 316L stainless basics? - by PixMan - 02-21-2015, 03:49 PM
RE: 316L stainless basics? - by f350ca - 02-21-2015, 06:10 PM
RE: 316L stainless basics? - by Roadracer_Al - 02-22-2015, 01:20 PM
RE: 316L stainless basics? - by PixMan - 02-22-2015, 03:55 PM



Users browsing this thread: 7 Guest(s)