02-20-2015, 06:45 PM
Tom spoke about helix angle in one of his videos Ed. I'd imagine it is in his tool bit grinding video but I could be wrong. I'd expect machenery's handbook to have the necessary data on cutting ACME threads.
Watching Ken make the elevation nut for my mill, I stressed to me that it is very easy to go from too tight to sloppy loose in one cut. So test often.
Watching Ken make the elevation nut for my mill, I stressed to me that it is very easy to go from too tight to sloppy loose in one cut. So test often.
Hunting American dentists since 2015.