MetalworkingFun Forum › Machining › General Metalworking Discussion v
316L stainless basics?

Thread Modes
316L stainless basics?
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
Bill Gruby (02-20-2015)
#4
02-20-2015, 09:01 AM
You'll be able to do a cold bend 316 over a 1/2t radius without issue. It's a bit tougher than mild steel though so it will take some effort. Rust is also not and issue on 300 series with normal exposure, even if it's welded.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
316L stainless basics? - by jawnn - 02-19-2015, 02:39 PM
RE: 316L stainless basics? - by PixMan - 02-19-2015, 10:05 PM
RE: 316L stainless basics? - by stevec - 02-20-2015, 07:28 AM
RE: 316L stainless basics? - by TomG - 02-20-2015, 09:01 AM
RE: 316L stainless basics? - by jawnn - 02-21-2015, 03:41 PM
RE: 316L stainless basics? - by PixMan - 02-21-2015, 03:49 PM
RE: 316L stainless basics? - by f350ca - 02-21-2015, 06:10 PM
RE: 316L stainless basics? - by Roadracer_Al - 02-22-2015, 01:20 PM
RE: 316L stainless basics? - by PixMan - 02-22-2015, 03:55 PM



Users browsing this thread: 2 Guest(s)