02-19-2015, 08:44 AM
(02-17-2015, 06:57 PM)EdK Wrote: I'm still not sure how to deal with this yet. I think I'll try to make some 29 degree and 30 degree gauges out of sheet metal in an attempt to find out what type of thread these lead screws are. I'd much rather make new nuts to fit the existing lead screws if I can. I hate that my mill is going to be down and out for some time but I'm glad I decided to check the nuts prior to deploying the X power feed. Just rambling here.
Ed
Just a thought, but wouldn't a standard fishtail gauge tell a story? go/no-go?