|
How to adjust?
|
02-18-2015, 08:00 PM
Yes Steve it's metric ,and it is backlash what i'm talking about but i couldn't think of the word i'm pretty poor at explaining things. But if i make a pass on a bit of material and then go back it takes more metal off you can go back and forth probaly 3or4 times without moving the cross feed and it will still take material off. I don't have much experiance but it just doesn't seam right.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to adjust? - by jeephaydon - 02-18-2015, 07:11 PM
RE: How to adjust? - by stevec - 02-18-2015, 07:24 PM
RE: How to adjust? - by DaveH - 02-18-2015, 07:35 PM
RE: How to adjust? - by jeephaydon - 02-18-2015, 08:00 PM
RE: How to adjust? - by stevec - 02-18-2015, 08:53 PM
RE: How to adjust? - by jeephaydon - 02-19-2015, 07:07 AM
RE: How to adjust? - by stevec - 02-19-2015, 07:16 AM
RE: How to adjust? - by Sunset Machine - 02-19-2015, 08:20 AM
RE: How to adjust? - by DaveH - 02-19-2015, 09:54 AM
RE: How to adjust? - by EdK - 02-19-2015, 12:37 PM
RE: How to adjust? - by stevec - 02-20-2015, 07:39 AM
RE: How to adjust? - by Micktoon - 02-20-2015, 06:50 PM
RE: How to adjust? - by Dr Stan - 02-21-2015, 08:16 PM
RE: How to adjust? - by jeephaydon - 02-23-2015, 01:49 PM
|
