MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tube Cutting

Thread Modes
Tube Cutting
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#7
02-18-2015, 10:28 AM
A cold saw with a 14" saw blade (round cutter) would be ideal, though pricey to get into one. It would also be faster than a bandsaw by quite a bit, andquieter than an abrasive chop saw but wider kerf for more loss of stock/pieces per bar.
Reply
Thanks given by:


Messages In This Thread
Tube Cutting - by Rainman1 - 02-18-2015, 08:28 AM
RE: Tube Cutting - by EdK - 02-18-2015, 08:36 AM
RE: Tube Cutting - by Rainman1 - 02-18-2015, 08:39 AM
RE: Tube Cutting - by EdK - 02-18-2015, 08:41 AM
RE: Tube Cutting - by Rainman1 - 02-18-2015, 08:43 AM
RE: Tube Cutting - by EdK - 02-18-2015, 08:48 AM
RE: Tube Cutting - by PixMan - 02-18-2015, 10:28 AM
RE: Tube Cutting - by Roadracer_Al - 02-19-2015, 02:26 AM
RE: Tube Cutting - by Rainman1 - 02-19-2015, 09:42 AM
RE: Tube Cutting - by Roadracer_Al - 02-20-2015, 02:08 AM



Users browsing this thread: 3 Guest(s)