MetalworkingFun Forum › Machining › General Metalworking Discussion v
Vice advice

Thread Modes
Vice advice
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
The following 2 users Like stevec's post:
EdK (02-17-2015), PixMan (02-17-2015)
#8
02-17-2015, 07:52 AM
As Darren (Mayhem) mentioned about the swivel base, make sure you really need one they eat up Z axis capacity and many of us have removed them due mainly to lack of use. 17428

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Vice advice - by mike-sid - 02-16-2015, 03:01 PM
RE: Vice advice - by JScott - 02-16-2015, 04:00 PM
RE: Vice advice - by Arbalest - 02-16-2015, 05:28 PM
RE: Vice advice - by mike-sid - 02-16-2015, 08:45 PM
RE: Vice advice - by Mayhem - 02-16-2015, 11:54 PM
RE: Vice advice - by Shawn - 02-17-2015, 12:06 AM
RE: Vice advice - by Mayhem - 02-17-2015, 07:35 AM
RE: Vice advice - by stevec - 02-17-2015, 07:52 AM
RE: Vice advice - by PixMan - 02-17-2015, 08:35 AM
RE: Vice advice - by mike-sid - 02-17-2015, 09:03 AM
RE: Vice advice - by Mayhem - 02-17-2015, 09:07 AM
RE: Vice advice - by EdK - 02-17-2015, 05:11 PM
RE: Vice advice - by mike-sid - 03-05-2015, 06:30 AM
RE: Vice advice - by Dr Stan - 02-17-2015, 09:01 PM
RE: Vice advice - by Mayhem - 03-05-2015, 08:25 AM
RE: Vice advice - by mike-sid - 03-05-2015, 09:19 AM
RE: Vice advice - by Mayhem - 03-05-2015, 09:42 AM
RE: Vice advice - by DaveH - 03-05-2015, 11:49 AM
RE: Vice advice - by arvidj - 03-05-2015, 01:24 PM
RE: Vice advice - by Highpower - 03-05-2015, 04:13 PM
RE: Vice advice - by mike-sid - 03-05-2015, 10:29 AM
RE: Vice advice - by stevec - 03-06-2015, 08:05 AM



Users browsing this thread: 4 Guest(s)