02-17-2015, 03:45 AM
Hi Shawn, nice lathe you havee there, I know Brook Crompton are good quality motors so worth trying to get it working rather than swapping it. I am no expert but looking at the motor plate it does not look like dual voltage type motor so you might have to dig into the windings to get it to run from an inverter.
I am sure others with more knowledge will comment further, good luck getting it sorted out.
cheers Mick
I am sure others with more knowledge will comment further, good luck getting it sorted out.
cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.