do I "need" a fly cutter, if I have a face mill

Hello There, Guest! Register

Thread Modes

do I "need" a fly cutter, if I have a face mill

Mayhem Offline

Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#7

02-16-2015, 06:25 AM

I believe Rob Wilson made himself one of those. His was much better finished though.

Hunting American dentists since 2015.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-15-2015, 08:02 PM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-15-2015, 08:07 PM

RE: do I "need" a fly cutter, if I have a face mill - by DaveH - 02-15-2015, 08:12 PM

RE: do I "need" a fly cutter, if I have a face mill - by f350ca - 02-15-2015, 11:15 PM

RE: do I "need" a fly cutter, if I have a face mill - by Arbalest - 02-16-2015, 05:21 AM

RE: do I "need" a fly cutter, if I have a face mill - by Arbalest - 02-16-2015, 05:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-16-2015, 06:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by Sunset Machine - 02-16-2015, 08:51 AM

RE: do I "need" a fly cutter, if I have a face mill - by PixMan - 02-16-2015, 08:31 PM

RE: do I "need" a fly cutter, if I have a face mill - by Micktoon - 02-17-2015, 03:30 AM

RE: do I "need" a fly cutter, if I have a face mill - by PixMan - 02-17-2015, 08:49 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-17-2015, 07:10 AM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-17-2015, 08:03 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-17-2015, 08:07 AM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-17-2015, 08:10 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-17-2015, 07:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-17-2015, 07:51 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-18-2015, 10:05 PM

Users browsing this thread: 2 Guest(s)