Form tools on the lathe
#14
Hi All,

Just a quick tip, I often use cheap carbide router cutters as form tools on both the lathe and the mill.  I use the 1/4" shaft ones.  Here is a couple of pictures of a job I did recently.

       
Best Regards:
Baron.

A member of MetalworkingFun Forum since Jul 2014.
Reply
Thanks given by: Shawn , stevec


Messages In This Thread
Form tools on the lathe - by Shawn - 01-28-2015, 05:40 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 05:46 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 06:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:10 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:20 PM
RE: Form tools on the lathe - by dallen - 01-28-2015, 07:42 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:50 PM
RE: Form tools on the lathe - by Highpower - 01-28-2015, 11:56 PM
RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:55 PM
RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:57 PM
RE: Form tools on the lathe - by Mayhem - 01-29-2015, 06:31 AM
RE: Form tools on the lathe - by dallen - 01-29-2015, 09:15 AM
RE: Form tools on the lathe - by vtsteam - 01-29-2015, 11:15 AM
RE: Form tools on the lathe - by Baron - 02-15-2015, 04:54 PM
RE: Form tools on the lathe - by Shawn - 02-16-2015, 11:10 PM



Users browsing this thread: 1 Guest(s)