02-15-2015, 01:39 PM
I'm looking to buy a knurling tool for my 13x30 Harrison lathe. I'm looking at a few projects, and knurling is required. Any advice on a good tool?
|
knurling tool advice
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
knurling tool advice - by mike-sid - 02-15-2015, 01:39 PM
RE: knurling tool advice - by EdK - 02-15-2015, 02:37 PM
RE: knurling tool advice - by mike-sid - 02-15-2015, 06:32 PM
RE: knurling tool advice - by EdK - 02-15-2015, 06:38 PM
RE: knurling tool advice - by dallen - 02-15-2015, 07:12 PM
RE: knurling tool advice - by dallen - 02-15-2015, 07:17 PM
RE: knurling tool advice - by mike-sid - 02-16-2015, 05:48 PM
RE: knurling tool advice - by EdK - 02-16-2015, 06:18 PM
RE: knurling tool advice - by TomG - 02-16-2015, 08:58 PM
|
Users browsing this thread: 2 Guest(s)