drill project

Thread Modes

drill project

ETC57

Junior

Posts: 576
Threads: 18
Joined: Feb 2012
Location: Washington State USA

#20

05-14-2012, 01:58 PM

(05-14-2012, 07:43 AM)stevec Wrote: I'm surprised to learn that the smaller drills were "soldered" into the tapers! How did you know that Bob?

Jerry.

ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.

« Next Oldest | Next Newest »

Messages In This Thread

drill project - by krv3000 - 05-13-2012, 01:35 PM

RE: drill project - by krv3000 - 05-13-2012, 01:52 PM

RE: drill project - by doubleboost - 05-13-2012, 02:03 PM

RE: drill project - by krv3000 - 05-13-2012, 02:31 PM

RE: drill project - by doubleboost - 05-13-2012, 02:37 PM

RE: drill project - by krv3000 - 05-13-2012, 04:39 PM

RE: drill project - by krv3000 - 05-13-2012, 04:05 PM

RE: drill project - by doubleboost - 05-13-2012, 04:11 PM

RE: drill project - by krv3000 - 05-13-2012, 05:11 PM

RE: drill project - by Rickabilly - 06-11-2012, 08:36 AM

RE: drill project - by doubleboost - 05-13-2012, 05:17 PM

RE: drill project - by krv3000 - 05-13-2012, 05:32 PM

RE: drill project - by krv3000 - 05-13-2012, 05:39 PM

RE: drill project - by Highpower - 05-13-2012, 09:15 PM

RE: drill project - by DaveH - 05-14-2012, 05:49 AM

RE: drill project - by Mayhem - 05-14-2012, 06:07 AM

RE: drill project - by stevec - 05-14-2012, 07:43 AM

RE: drill project - by EdK - 05-14-2012, 08:19 AM

RE: drill project - by ETC57 - 05-14-2012, 01:58 PM

RE: drill project - by Mayhem - 05-14-2012, 08:27 AM

RE: drill project - by krv3000 - 05-15-2012, 01:58 AM

RE: drill project - by krv3000 - 06-05-2012, 06:06 PM

RE: drill project - by stevec - 06-11-2012, 03:24 PM

Users browsing this thread: 3 Guest(s)