MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
sharpening end mills by hand.

Thread Modes
sharpening end mills by hand.
fix Offline
Sophmore
***
Posts: 53
Threads: 4
Joined: Jan 2015
Location: Charleston, Il.
#5
02-10-2015, 08:33 PM
I don't trust myself on the grinder.
I even use the stones to sharpen drill bits.
It seems like once I get down to drill bits that are smaller than 1/4 inch, I just make them shorter rather than sharper.
Reply
Thanks given by:


Messages In This Thread
sharpening end mills by hand. - by fix - 02-10-2015, 03:59 PM
RE: sharpening end mills by hand. - by Terry S - 02-10-2015, 07:10 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 07:32 PM
RE: sharpening end mills by hand. - by f350ca - 02-10-2015, 08:17 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 08:33 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 08:52 PM
RE: sharpening end mills by hand. - by Dr Stan - 02-10-2015, 10:54 PM
RE: sharpening end mills by hand. - by PixMan - 02-11-2015, 11:38 PM
RE: sharpening end mills by hand. - by krv3000 - 02-14-2015, 03:27 PM



Users browsing this thread: 3 Guest(s)