mill head to table align'

Thread Modes

mill head to table align'

Dr Stan Offline

Senior

Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines

02-09-2015, 11:21 PM (This post was last modified: 02-09-2015, 11:22 PM by Dr Stan.)

A couple general pieces of advise on mill traming:

1) take small steps as it is way too easy to go to far

2) smoothly pull on the wrench tightening the fasteners working back & forth between them. Don't yank on it.

3) sweep a circle as close in size as possible as the width of the table.

BTW, it gets easier with practice.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

mill head to table align' - by chanse - 02-08-2015, 09:02 PM

RE: mill head to table align' - by Highpower - 02-09-2015, 12:46 AM

RE: mill head to table align' - by fix - 02-09-2015, 11:13 AM

RE: mill head to table align' - by Vinny - 02-09-2015, 03:07 PM

RE: mill head to table align' - by Dr Stan - 02-09-2015, 11:21 PM

RE: mill head to table align' - by chanse - 02-11-2015, 08:55 PM

RE: mill head to table align' - by Shawn - 02-19-2015, 01:56 AM

RE: mill head to table align' - by Roadracer_Al - 02-19-2015, 02:08 AM

RE: mill head to table align' - by Shawn - 02-19-2015, 10:14 AM