02-07-2015, 03:52 PM
couple of bits produced, little scuff on the pin punch 6mm shaft
|
new to turning and milling!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
new to turning and milling! - by tina and the turners - 02-05-2015, 04:53 PM
RE: new to turning and milling! - by Highpower - 02-05-2015, 05:01 PM
RE: new to turning and milling! - by DaveH - 02-05-2015, 05:08 PM
RE: new to turning and milling! - by TomG - 02-05-2015, 06:33 PM
RE: new to turning and milling! - by Highpower - 02-05-2015, 10:52 PM
RE: new to turning and milling! - by tina and the turners - 02-06-2015, 01:33 AM
RE: new to turning and milling! - by schor - 02-07-2015, 05:22 PM
RE: budding machinist - by tina and the turners - 02-07-2015, 03:52 PM
|
Users browsing this thread: 1 Guest(s)