02-07-2015, 11:47 AM
Hi Ken (got it right this time 
)
Glad it came out
Looks overall a nice mill, so long as you use it within it's capabilities it will give you good service.
It may need a bit of a clean up - the spindle bearing may need to be replaced, there again they may be fine.
Just because it was made in China does not mean it was designed in China.
DaveH
)Glad it came out
Looks overall a nice mill, so long as you use it within it's capabilities it will give you good service.
It may need a bit of a clean up - the spindle bearing may need to be replaced, there again they may be fine.
Just because it was made in China does not mean it was designed in China.
DaveH