MetalworkingFun Forum › Machining › General Metalworking Discussion v
Sight glass replacement advice

Thread Modes
Sight glass replacement advice
mike-sid Offline
Sophmore
***
Posts: 137
Threads: 16
Joined: Jan 2015
Location: Oxford, CT
#7
02-06-2015, 08:59 PM
Can't beat that Ken. If I buy one I'll check them out.

My current problem is to figure out if the sight glass is pressed in or threaded in.
Reply
Thanks given by:


Messages In This Thread
Sight glass replacement advice - by mike-sid - 02-05-2015, 11:41 PM
RE: Sight glass replacement advice - by Highpower - 02-06-2015, 12:39 AM
RE: Sight glass replacement advice - by mike-sid - 02-06-2015, 06:27 AM
RE: Sight glass replacement advice - by EdK - 02-06-2015, 06:37 AM
RE: Sight glass replacement advice - by TomG - 02-06-2015, 08:39 AM
RE: Sight glass replacement advice - by PixMan - 02-06-2015, 01:35 PM
RE: Sight glass replacement advice - by mike-sid - 02-06-2015, 08:59 PM



Users browsing this thread: 3 Guest(s)