MetalworkingFun Forum › Machining › General Metalworking Discussion v
Sight glass replacement advice

Thread Modes
Sight glass replacement advice
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
Highpower (02-06-2015)
#5
02-06-2015, 08:39 AM
I doubt that you will need to replace it, but you will need to get it out. Varnish building up on the glass from the non-detergent oil is what made it dark. If you can get the sight glass off, all you need is a little alcohol to clean it.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Sight glass replacement advice - by mike-sid - 02-05-2015, 11:41 PM
RE: Sight glass replacement advice - by Highpower - 02-06-2015, 12:39 AM
RE: Sight glass replacement advice - by mike-sid - 02-06-2015, 06:27 AM
RE: Sight glass replacement advice - by EdK - 02-06-2015, 06:37 AM
RE: Sight glass replacement advice - by TomG - 02-06-2015, 08:39 AM
RE: Sight glass replacement advice - by PixMan - 02-06-2015, 01:35 PM
RE: Sight glass replacement advice - by mike-sid - 02-06-2015, 08:59 PM



Users browsing this thread: 1 Guest(s)